AndyF
Stainless
- Joined
- Nov 3, 2003
- Location
- Phelps, NY, USA
I bit the bullet this week and purchased a used Delta 7.5hp dust collector for my new shop and will be installing a duct system to my stationary machines as well as two floor sweeps. What are good sources for ducts and the other fittings I'll need. I've found Oneida on line and google came up with a bunch of other names also.
The system I'll be putting in will have connections to the following: 20" 10hp planer, 5hp tablesaw, 3hp shaper, drill press, lathe, 6x42 belt sander, 8" jointer, 18" bandsaw and 2 floor sweeps. At some point, I may also be adding a downdraft table and wide belt sander.
I'm looking for spiral duct and fittings up to 8" dia. for the system.
The system I'll be putting in will have connections to the following: 20" 10hp planer, 5hp tablesaw, 3hp shaper, drill press, lathe, 6x42 belt sander, 8" jointer, 18" bandsaw and 2 floor sweeps. At some point, I may also be adding a downdraft table and wide belt sander.
I'm looking for spiral duct and fittings up to 8" dia. for the system.