dave morgan
Aluminum
- Joined
- Mar 24, 2018
Hello all,
New member here and first post seeking assistance with Fagor 8055i/B-T control.
This control is on a 2006 DMTG flatbed lathe.
The lathe was relocated this past summer and has not run a stored program for several years.
The problem is that it will run the old stored programs but it will not run a newly entered program created on the Conversational or ISO format.
If I enter a new program # in the ISO format using the same code as an old stored program it gives a message (PLEASE CLOSE THE DOOR). If I enter a new program # using the Conversational side it throws the same message (PLEASE CLOSE THE DOOR)
When I toggle between the CO and M/T modes I can see differences in the program. The MT mode screen appears to be calling a subprogram but there is no subprogram shown on the CO mode screen.
Any assistance with this will be much appreciated.
Thanks,
Dave
New member here and first post seeking assistance with Fagor 8055i/B-T control.
This control is on a 2006 DMTG flatbed lathe.
The lathe was relocated this past summer and has not run a stored program for several years.
The problem is that it will run the old stored programs but it will not run a newly entered program created on the Conversational or ISO format.
If I enter a new program # in the ISO format using the same code as an old stored program it gives a message (PLEASE CLOSE THE DOOR). If I enter a new program # using the Conversational side it throws the same message (PLEASE CLOSE THE DOOR)
When I toggle between the CO and M/T modes I can see differences in the program. The MT mode screen appears to be calling a subprogram but there is no subprogram shown on the CO mode screen.
Any assistance with this will be much appreciated.
Thanks,
Dave