gearco
Aluminum
- Joined
- Jan 10, 2010
- Location
- Atlanta, GA
View attachment 64414View attachment 64415View attachment 64416View attachment 64417View attachment 64418
I've had this several years and used it occasionally for polishing and turning down parts; replaced the belts and last year replaced the back gear with a NOS part i got from Joe at Plaza Machinery. The lathe came to me with broken teeth on the back gear and it took me quite a while to find a replacement as repairing the helical teeth looked doubtful. Joe had a new one still in wax paper. It has a Bison chuck with moderate wear and a chip out of one of the tightening points. The motor looks original and it's 220, three phase. I'm sure the paint is not original. As most lathes of this vintage- it was made around 1958- it has some wear on it but is very serviceable. Asking $1600; i'm in Atlanta. If interested, please send me a PM or email me at [email protected]
I've had this several years and used it occasionally for polishing and turning down parts; replaced the belts and last year replaced the back gear with a NOS part i got from Joe at Plaza Machinery. The lathe came to me with broken teeth on the back gear and it took me quite a while to find a replacement as repairing the helical teeth looked doubtful. Joe had a new one still in wax paper. It has a Bison chuck with moderate wear and a chip out of one of the tightening points. The motor looks original and it's 220, three phase. I'm sure the paint is not original. As most lathes of this vintage- it was made around 1958- it has some wear on it but is very serviceable. Asking $1600; i'm in Atlanta. If interested, please send me a PM or email me at [email protected]