Norm - ITTGOco
Plastic
- Joined
- Aug 22, 2005
- Location
- U.S.A. Maryland, Baltimore, Hampden.
Has any one here ever cut aluminum on a table saw?
My job will entail some 3/16" thick X 2" straight cuts,and some 3/8" thick X 1" straight cuts also.
I have never done this. However looking at it it is tempting using a 10" blade with 80 teeth. Could be a risky,that's why I am asking if any one has tried it.
My job will entail some 3/16" thick X 2" straight cuts,and some 3/8" thick X 1" straight cuts also.
I have never done this. However looking at it it is tempting using a 10" blade with 80 teeth. Could be a risky,that's why I am asking if any one has tried it.