viper
Titanium
- Joined
- May 18, 2007
- Location
- nowhereville
We have a couple part numbers we are quoting that require knurls. I am curious what I need to know to knurl a part? I have always wondered if the diameter of the knurl wheel needs to be of a certain size compared to the part? I am just wondering about the knurls of one rev not lining up with the next and they get all smooshed together.
Is there a certain way to feed a thinner knurl over a longer Z length and make it all look uniform? What kind of feeds/speeds are we looking at for this?
One part is Al and one part is SS which kind of worries me.
Is there a certain way to feed a thinner knurl over a longer Z length and make it all look uniform? What kind of feeds/speeds are we looking at for this?
One part is Al and one part is SS which kind of worries me.