BpWhight
Plastic
- Joined
- Dec 27, 2014
I Have a Mitutoyo Digimatic DRO system installed on my Milling Machine which I am looking for a pinout for the Scales 9 pin connector.
Display 982-537-1
13" Scale 572-125
30" Scale 572-132
I want to run the Scales on a Fagor 40i Display I have.
The Fagor has a 15 pin connector, I have a Pinout for this.
The scales have a 9 pin connector, I need a Pinout for this one.
I have done my research and every single link to a Mitutoyo Digimatic Manual has gone cold. Mitutoyo dosen't have any support for these scales anymore as they were produced in the 90's
Now while I can buy an adapter, I need to be able to verify that the signal, 5V, and grounds are correct.
If I get ahold of a Manual I will type the pinout here for future generations as links will always go cold eventually.
Display 982-537-1
13" Scale 572-125
30" Scale 572-132
I want to run the Scales on a Fagor 40i Display I have.
The Fagor has a 15 pin connector, I have a Pinout for this.
The scales have a 9 pin connector, I need a Pinout for this one.
I have done my research and every single link to a Mitutoyo Digimatic Manual has gone cold. Mitutoyo dosen't have any support for these scales anymore as they were produced in the 90's
Now while I can buy an adapter, I need to be able to verify that the signal, 5V, and grounds are correct.
If I get ahold of a Manual I will type the pinout here for future generations as links will always go cold eventually.