ARB
Titanium
- Joined
- Dec 7, 2002
- Location
- Granville,NY,USA
I am getting
103 X servo motor error too large
139 X motor Z Fault
1994 VF3 DC Brush machine.
I switched x and y drives and get the same error.
I also seem to lose postion when it happens and have to referernce the axis before i can continue.
This is an intermittent problem getting worse.
Is this the motor, the encoder, or cabling?
I pulled the brushes and vacuumed the dust out as best I could and replaced the brushes. They looked to be about half gone.
????
Any insight before I call the dealer.
TY ARB
103 X servo motor error too large
139 X motor Z Fault
1994 VF3 DC Brush machine.
I switched x and y drives and get the same error.
I also seem to lose postion when it happens and have to referernce the axis before i can continue.
This is an intermittent problem getting worse.
Is this the motor, the encoder, or cabling?
I pulled the brushes and vacuumed the dust out as best I could and replaced the brushes. They looked to be about half gone.
????
Any insight before I call the dealer.
TY ARB