FreediveShop_hb
Plastic
- Joined
- May 2, 2009
- Location
- CA
Hey guys I'm sure you probably answer the same questions over and over from new guys but I know next to nothing and need it answered.
I run a small spearfishing shop and I want to thread steel shafts up to 5/16 or 8mm as cheaply as possible.
The thing I can't figure out is can a mini lathe handle spring steel or heat treated shaft up to 160cm long? If not what will?
What can I say I never took only took woodshop in HS. Any help would be greatly appreciated
I run a small spearfishing shop and I want to thread steel shafts up to 5/16 or 8mm as cheaply as possible.
The thing I can't figure out is can a mini lathe handle spring steel or heat treated shaft up to 160cm long? If not what will?
What can I say I never took only took woodshop in HS. Any help would be greatly appreciated