squinn2185
Plastic
- Joined
- Feb 8, 2020
hello,
I'm trying to run a complex program on the 620 multiplex with mazatrol t32. The part I'm running has a cross hole on the od so I offset the c axis on head 1 for that to make sure I didn't hit any of the jaws.im also drilling a bolt circle pattern on the face but I'm doing that on head 2. My question is do I need to offset the head 2 c axis as well? and if so do I need to offset it the same amount?
I'm trying to run a complex program on the 620 multiplex with mazatrol t32. The part I'm running has a cross hole on the od so I offset the c axis on head 1 for that to make sure I didn't hit any of the jaws.im also drilling a bolt circle pattern on the face but I'm doing that on head 2. My question is do I need to offset the head 2 c axis as well? and if so do I need to offset it the same amount?