martin_05
Hot Rolled
- Joined
- Mar 11, 2009
- Location
- Valencia, CA, USA
...other than not using tabs an using a completely different approach.
These parts are motor mounts for an internal project, so the nicks don't really matter. I'm just trying to figure out how to prevent them for when the outer surface finish actually does matter.
Any secret techniques out there? One thought was to take a skim cut rather than a full width cut to the wall.
Thanks.
These parts are motor mounts for an internal project, so the nicks don't really matter. I'm just trying to figure out how to prevent them for when the outer surface finish actually does matter.
Any secret techniques out there? One thought was to take a skim cut rather than a full width cut to the wall.
Thanks.