Delete

[jpointer311]

Warner Swasey No.2 lathe with all tooling shown. 53 collets round bar and hex.

Check out the photos for all included tooling. Some is hardinge not related to this machine but comes with it. Unless someone wants to purchase it separately.

Tons of thread Chasers for the geometric die heads.

3 albreicht chucks, one needs to be taken apart and cleaned and put back together.

I do not have a vfd or 3 phase to demo the unit. Bought from a shop closing down and took his word it functioned as it should.

2500 or best offer for the lot.

Call or text - josh

Located in debary fl
.

 

[jpointer311]

More photos

 

[jpointer311]

The hardinge tooling is a turret assembly, collet draw bar, cross slide and possibly a couple other items.

Also comes with spare warner swasey turret assembly with a spare set of screws. Spare 1/2hp motor unknown working condition.

 

[gbent]

There is a poster on the main forum looking hard to cut 5/8-11 threads with a die head. Make him a deal before you have to tote the whole thing to scrap.

 

[michiganbuck]

That is a real workhorse for a production part, and it looks in good shape.

 

[jpointer311]

There is a poster on the main forum looking hard to cut 5/8-11 threads with a die head. Make him a deal before you have to tote the whole thing to scrap.

I will take a look and get in touch with him. Thank you.

Hopefully i don't have to scrap it all, has to be of value to someone.

 

[DDoug]

I will take a look and get in touch with him. Thank you.

Hopefully i don't have to scrap it all, has to be of value to someone.

Selling off those (3) die heads with chasers as a set to someone is not considered a bad thing.
Selling off the turret, collets, and items that came with the lathe from W&S is another.

 

[jpointer311]

Got it. Thanks!

 

[noclue2004]

Do you have any dies for a 9/16 Die head by chance?

 

[jpointer311]

Do you have any dies for a 9/16 Die head by chance?

Probably 70 Chasers for 9/16d

 

[jpointer311]

Found a local guy that needed the tooling since i didn't get any interest. Last call, 500.00 for the complete machine with the 50+ collets.

I will also sell parts and pieces if you need anything before it goes off to be melted down.

Collets will be available if anyone needs them after the machine is scrapped. I can fit 18 in a large flat rate. Shipping 26.50 insured.

 

[truc]

sending you a PM.

 

[Garwood]

You can't even get scrap price for late model square head W&S lathes right now and scrap price is nothing.

I would feel very thankful if I got someone to show up and hand me $100 to load that lathe with collets on their trailer.

I just sold a nice older CNC lathe for $600. The buyer was willing to pay that much because the chuck was worth that much and I could load it easily.

 

[jpointer311]

That seals the deal then. I'll load it up and send to scrap.