My Mazak nexus 550m slant bed reads the rapid retract m32 from its set position and sends my tail stick home. BUT! Even though I teach it and put
MO or Mo1
mo5
m741
m31
Or mo5 swap the m741&m31. It seems to ignore the 741 but reads the m31 and approaches my workpiece but very very slow. WHY??? I can’t figure it out.
MO or Mo1
mo5
m741
m31
Or mo5 swap the m741&m31. It seems to ignore the 741 but reads the m31 and approaches my workpiece but very very slow. WHY??? I can’t figure it out.