Looking for super low profile 4mm OD tube to m6 mnpt to run grease lines to ball screws

[Anathema]

I'm hoping I can find something that will work for this I need a connector for 4mm OD tube to m6 male. I only have roughly 1/2 inch of clearance to make it fit. If I cant I may try to make my own with some brass tube, but I'd rather not.

 

[Peter from Holland]

Make a fitting you can solder on perhaps. 6mm brass rod with a 4mm hole on one end and M6 on the other end Oke It is a bit short but possible depending on the minimum lenght of the m6 male
Silver soldering does not need that much le ght But soft solder contaibing silver is also pretty strong
Peter

 

[Erich]

what type of tube? plastic, metal rubber? hose barb or instant or compression?

 

[Erich]

Miniature 90° Male Elbow Hose Barb Brass

.078 (2mm) ID Hose Barb x M6 Male, 90° Male Elbow, Hose Barb, Brass Fitting

www.universalpowerconversion.com

 

[Bill D]

Banjo fitting?

 

[true temper]

Check with these guys, I have got grease tube from them.

 

[Anathema]

Miniature 90° Male Elbow Hose Barb Brass

.078 (2mm) ID Hose Barb x M6 Male, 90° Male Elbow, Hose Barb, Brass Fitting

www.universalpowerconversion.com

This looks like it might work out. Thank you,